OneUp OneUp Dropper Post Remote 22.2 Clamp
OneUp Dropper Post Remote - Bicicletta
OneUp OneUp Dropper Post Remote I-Spec

OneUp Dropper Post Remote

Size
Online Only
Warehouse Inventory Broadway Inventory
MatchMaker X Out of Stock Sold Out Out of Stock Sold Out
22.2 Clamp Out of Stock Sold Out Out of Stock Sold Out
I-SPEC Out of Stock Sold Out Out of Stock Sold Out


In Stock In Stock - 5 or more in stock.
Inventory Warning Low Stock - Less than 5 left in stock.
Out of Stock Sold Out - Cannot be ordered at this time.


Please note that components are subject to change and may not be exactly as pictured.


A carbon remote with an oversized bearing and a super smooth action. The unique lever position allows you to keep a stronger grip on the bars while actuating your post. Don't think twice about dropping your post, even when charging into technical sections. The OneUp lever mimics your R/H shifter' inboard upshift paddle position instead of the usual downshift paddle position of most remotes. This position requires considerably less thumb movement to reach the lever.

Specifications
22.2mm Clamp
  • Loosely attach the hinged clamp to your handlebar (Left side of brake for SRAM, Right side of brake for Shimano)
  • Attach the remote body to the clamp using your preferred mounting hole.
  • Torque the remote body to the clamp using a3mmhex to 3Nm
  • Loosen the 22.2mm clamp and rotate theOneUp dropper remoteuntil the remote body is parallel to the brake lever
  • Snug the 22.2mm clamp to 1Nm max
Shimano I-spec II
  • Remove the lever mounting bolt completely from the left brake using a 4mm hex
  • Depress the "Push to Open" button using a 2mm hex to fully open the brake lever clamp
  • Remove the plastic spacer from the inside of the lever clamp
  • Installthe OneUp I-spec II adapter into the lever clamp
  • Loosely reinstall the brake lever clamp onto the handlebar
  • Attach the remote body to theI-specIIadapter using your preferred mounting hole.
  • Torque the remote body to the I-specII adapter using a3mmhex to 3Nm
  • Rotate the OneUp dropper remote until the remote body is parallel to the brake lever.
  • Torque the brake lever clamp to the manufacturer's recommendation
SRAM Matchmak
  • Remove Brake lever mounting screw and hinged clamp using a T25 Torx
  • Installthe OneUp supplied T-nut into the curved recess on the hinged clamp
  • Loosely reinstall the brake lever clamp onto the handlebar
  • Installthe OneUp supplied Matchmaker X adapter onto the T-nut
  • Attach the remote body to the Matchmaker X adapter using your preferred mounting hole.
  • Torque the remote body to the Matchmaker X adapter using a3mmhex to 3Nm
  • Rotate the OneUp dropper remote until the remote body is parallel to the brake lever.
  • Torque the brake lever clamp to the manufacturer's recommendation

You may also like


Recently viewed